How to Start a Car with a Dead Battery Without Another Car

How to start a car with a dead battery

Do you want to see how to start a car with a dead battery without another car; this is the post for you.

In this post, we will consider how to start a car with a dead battery and even how to start an automatic car with a dead battery without another car.

So if you are concerned in any of these areas listed, then stick around to the end as we consider each aspect.

There is no argument true that someone can suffer from a dead car battery for a whole bunch of reasons.

Sometimes it is ether due to the fact that you left your car lights on forgetfully or due to the fact that your battery is old.

This is why it not out place for most car owners faced a dead battery problem sooner or later.

And that is also the reason you need to learn or be aware of how you can start a dead battery without another car in case of an emergency or your car stopping where it not meant to.

Normally, the most common way to deal with a dead battery is to jump-start it.

And all you need to jump-start a car is a set of jumper cables and another car that has a functional battery.

Please ensure you don’t try to jump-start a car if its battery is cracked and is visibly leaking acid.

Related Article:

• How Long Does it Take to Charge a Car Battery While Driving?
• How Long Do You Need to Drive a Car to Recharge a Dead Battery
• How to Check Prius Hybrid Battery Health (How to Test Prius Battery Cells)

How to Start a Car with a Dead Battery Without Another Car (How to Start a Car with a Dead Battery)

Here is various aspect of starting a dead battery we will consider in this post. So feel welcomed to navigate to the area that most interest you.

• how to start dead battery car
• how to start a car with a dead battery without another car
• dead battery without another car
• how to jumpstart an automatic car without another car
• how to start an automatic car with a dead battery
• how to start an automatic car with a dead battery without another car
• jump start car with drill battery
• how to start a car without a battery
• How to: jumpstart a car with household items

So with those in mind let’s get started with how to start dead battery car.

HOW TO START DEAD BATTERY CAR

Most time it is hard to predict the situations in which you have to start your car with a dead battery.

But the idea you can use is to position your car on elevated terrain, and the incline will make it easy for you to get the car moving and achieve the momentum that is required to start your car.

But if the road is flat and your car is too heavy to move, you might need a person or two to help push the car.

These extra force will give the car enough momentum, while the spare hands are pushing your car, you can turn on the ignition and switch your car to second gear.

You can then wait for your car to build up some momentum before you release the clutch quickly.

But if your car doesn’t start, press the clutch over and over again.

HOW TO START A CAR WITH A DEAD BATTERY WITHOUT ANOTHER CAR

Please make sure to be careful whenever you are working with your car, whether you are changing oil or replacing the serpentine belt.

This jump start battery you are to use should have good safety features. If not, there could be a safety risk once you connect the jumper cables to the wrong terminal.

So what will happen? You mixing up with positive and negative connections may create a short burst or a firework leaving your battery toasted.

However, in case of jumpstarting an automatic car, it is crucial for the gear to be in a Neutral position when you are restarting the car.

If not, the car will hurtle down the driveway like a bullet and will cause an accident.

HOW TO JUMPSTART AN AUTOMATIC CAR WITHOUT ANOTHER CAR

Please note that push starting entails pulling or pushing a car until it picks up some momentum.

But this is not recommended for car owners to try this method on automatic cars, because it can be difficult to determine how fast the car can go, and this can also end up damaging the brakes.

Here are what to do:

• Make sure you set the start key on position, and then find some people to push the car from behind until it gathers some speed
• Once you do this, release both the handbrake and footbrake after the vehicle gets in motion
• After this, step carefully on the gas pedal and make sure that the car’s gear is on a drive
• Your car will start and once the car’s speed is stable, fire the ignition and keep working on the gas in small gentle steps
• After some time, your vehicle’s battery should be fully charged and ready to move you to any place you want to go.

HOW TO START AN AUTOMATIC CAR WITH A DEAD BATTERY

You will begin by jump starting your automatic transmission, you will have to use another car’s battery to bring yours back to life.

Make sure to connect the booster cables which will transmit the energy and power from that car’s cell directly into your own dead battery.

Always remember that you can’t connect to just any other battery with your car to jump start it.

This means that if the battery of the other car has a voltage that is higher than yours, this could cause a lot of damage to your car’s battery. 

Note that most cars have 12-volt batteries, so ensure you find another car with the same voltage. 

Once the battery is properly connected to your hot engine, give it enough time for the power surge to hit the dead battery which can take several minutes.

Please don’t rev the engine to initiate a surge of power.

And once the vehicle cranks, you can disconnect the cables by taking off the positive first and then the negative (without letting them touch each other). 

JUMP START CAR WITH DRILL BATTERY

Step 1.

To do this, you’ll need a fully charged battery from a drill or other power tool.

Ensure that the battery is fully charged, this is because a half charged battery might not give you enough power.

Note that batteries between 12v – 18v should work just fine.

You can connected small alligator clips to extend the battery terminals, then put a sponge between the clips to avoid accidental surge.

Step 2.

You now connect the positive (+) clip to the dead battery, and then the other end to the drill’s battery.

Step 3.

After this, connect the negative (-) clip to the drill’s battery and the other end of the cable to the unpainted metal part of the car.

Then wait for 5 – 10 minutes before trying to start the car.

Once done and you’re lucky, you’ll be able to drive away.

HOW TO START A CAR WITHOUT A BATTERY

This depends if the car is manual (Easy) or automatic (Hard to impossible).

• For the manual: ensure you select the second gear, press the clutch pedal. Find 3 to 4 people to push the car until you reach about 2 MPH or more, then drop the clutch, hopefully the car will start.

Another way is to manually tow the car up to 5–10MPH and then select 2nd or 3rd gear, drop the clutch. Hopefully the car will start.

• For automatic cars: this only works with some cars. You can select the drive, then tow the car up to about 20MPH. But in case it doesn’t work on the first attempt, call your mechanic.

HOW TO JUMPSTART A CAR WITH HOUSEHOLD ITEMS

Using laptop charger

Well, some laptop charging bricks can be used, just look for ones that has 15 volts or so.

Then keep tabs on it, the charger brick may get a bit warm, as the battery that are big will have pretty low internal resistance.

But you might want to consider an incandescent bulb in series with the charging lead to limit current. I would use a headlight bulb to start.

UPS

Now do you have a UPS? If you do, they typically use lead acid batteries, and thus have a decent charging circuit.

One of the issue you might have is that if they are of any sort of size, maybe 24 volts inside which uses two 12 volt SLA bricks in series, and might be really small only 6 volt.

You can sub in the car battery for one of the 12-volt packs in a 24-volt system leaving the other.

Using coke

What you should do first, pop your hood and take a look at the battery. Once the terminals are really corroded, you can use a can of Coke to clean them up.

This because it has a relatively low pH, carbonic acid, citric acid, and phosphoric acid, as well as carbonation. And when combined, they can break down the corrosion.

when done, it will make things a bit sticky, but it will ensure the removal of the corrosion and help make a better connection between the terminals and the battery clamps. But always remember, this is only a temporary fix.   

This basically  is how you jumpstart a car with household items

Summary  on how to start a car with a dead battery without another car

In this post, I have shown you how to start a car with a dead battery and even how to start a car with a dead battery without another car.

I hope this post helped you.

If you find this to be helpful, please share it and bookmark it too for feature reference.

Also read this Post: How Long Does it Take to Charge a Car Battery While Driving?

Source